Back to Blog
Tutorials••7 min read

How Much Does It Cost to Install Central Air Conditioning?

Installing central air conditioning costs $5,000 to $15,000 when the home already has usable ductwork, and $9,000 to $18,000 when new ducts are needed. This is a first install — not a replacement, which costs far less.

How Much Does It Cost to Install Central Air Conditioning?

How Much Does It Cost to Install Central Air Conditioning?

Installing central air conditioning costs $5,000 to $15,000 when the home already has usable ductwork, and $9,000 to $18,000 when new ducts have to be installed as well. A straight replacement of an old unit — swapping one box for another on ducts that already exist — costs $3,500 to $7,500, which is a different job at a different price, and the one this guide is not about.

That distinction is the first thing to get straight, because it is the source of most quote confusion in this market. A first-time installation may require new ducts, new electrical service, and a new air handler before the cooling equipment can even be connected. A replacement needs none of that. If two quotes for your home differ by $5,000, one of them is almost certainly pricing a different job.

Central AC Installation Cost at a Glance

The table below shows typical prices in the United States, checked Nov 11, 2026 (sources: Fixr, Bryant, Homewyse, and 2026 installer guides).

ItemTypical cost
With usable ductwork$5,000–$15,000
With new ductwork$9,000–$18,000
Replacement (existing ducts, old unit out)$3,500–$7,500
3-ton system, typical$6,000–$9,500
Full HVAC (AC + furnace)$7,000–$16,000
Labour$1,500–$3,500
Permit$100–$400
Job time (first install)2–3 days

Fixr's 2026 data puts a central AC install at $5,000 to $12,000 with many 3-ton systems around $6,000, and a national average near $5,900, with most projects between $3,600 and $8,200. Bryant, the manufacturer, gives a wider $5,000 to $28,000 for an installed residential system — the top end covers high-efficiency equipment in large homes. The $5,000 to $15,000 band above is the planning range for a standard first install with ducts in place.

First Install vs Replacement: The $5,000 Gap

The two jobs share a condenser and an air handler, and almost nothing else.

A replacement reuses the ducts, the electrical connections, and the air handler location. The crew removes the old outdoor unit and indoor coil, sets the new ones, connects the refrigerant lines, and tests the system — usually in 4 to 8 hours. That is why it costs $3,500 to $7,500.

A first install starts from nothing. The crew must run ductwork through the house, fit an air handler and evaporator coil, run a new electrical circuit, set a concrete pad and the outdoor condenser, and charge the refrigerant lines. New ductwork alone typically adds $3,000 to $8,000, and a complex first-time install in an older home can reach $12,000 to $18,000 or more — difficult retrofits in old houses run $15,000 to $20,000 and up.

JobWhat is reusedTypical costTime
ReplacementDucts, wiring, air handler spot$3,500–$7,5004–8 hours
First install, ducts usableDucts only$5,000–$15,0002–3 days
First install, new ductsNothing$9,000–$18,0002–3 days
First install, difficult retrofitNothing$15,000–$20,000+3–5 days

Ask the contractor which job the quote prices, and whether the ducts are assumed usable. A quote that assumes usable ducts on a home with undersized or leaking ducts is a quote that will grow by thousands mid-job.

Cost by Tonnage: Size Sets the Equipment Price

Central AC size is measured in tons — one ton cools about 12,000 BTU an hour, or roughly 500 to 600 square feet of living space. The tonnage sets the equipment price; the ductwork sets the rest.

System sizeEquipment onlyInstalled (with ducts)
1.5 ton$2,500–$4,500$4,500–$7,500
2 ton$3,100–$5,100$5,500–$9,000
2.5–3 ton$3,400–$5,400$6,000–$10,500
3.5–4 ton$4,200–$6,200$8,000–$14,000
5 ton$4,300–$6,800$10,000–$17,000+

By home size, the pattern is: up to 1,000 square feet takes 1.5 to 2 tons; 1,000 to 1,500 takes 2 to 2.5 tons; 1,500 to 2,000 takes 2.5 to 3 tons; 2,000 to 2,500 takes 3 to 3.5 tons; and 3,000-plus takes 4 to 5 tons. A 2-ton system suits most 1,200-square-foot homes; a 3-ton unit handles 1,800 to 2,000 square feet.

Bigger is not better. An oversized unit cools the air too fast, shuts off before it dehumidifies, and cycles on and off all day — which wears it out and leaves the house clammy. A proper installer does a Manual J load calculation — a room-by-room measurement of heat gain through windows, walls, and roof — instead of sizing by square footage alone. If a contractor sizes by square feet only, that is a quote to question.

SEER2 Efficiency Tiers

SEER2 (Seasonal Energy Efficiency Ratio 2) replaced the old SEER rating in January 2023, and it is a stricter test — the same unit scores lower under SEER2 than it did under SEER, so old SEER numbers and new SEER2 numbers are not comparable.

Since 2023, new central ACs must meet Department of Energy minimums of 13.4 SEER2 in the North and 14.3 SEER2 in the South for most home systems. Installing a unit below your region's minimum is illegal and can result in fines, voided warranties, and disqualification from rebates and tax credits.

Efficiency tierSEER2Effect on price
Minimum legal13.4–14.3Baseline
Mid-efficiency15–17+$1,000–$2,500 over minimum
High-efficiency18–20++$3,000–$6,000 over minimum

Higher SEER2 costs more up front and less to run. In a hot climate where the AC runs six months a year, the high-efficiency unit can pay back; in a mild climate where it runs eight weeks, it usually does not. The payback question is a climate question, not a quality question.

New systems sold from 2025 also use lower-impact refrigerants such as R-454B and R-32, which has pushed equipment prices up. And one credit is gone: the federal Energy Efficient Home Improvement Credit for qualifying central air conditioners — 30 percent of project cost up to $600 — applied only to equipment placed in service through December 31, 2025. The IRS states it is not allowed for property placed in service after that date, so a 2026 purchase should not assume it.

A Worked Example: First Install in a 2,000-Square-Foot Home

Take a homeowner adding central air for the first time to a 2,000-square-foot home with usable ducts, choosing a 3-ton mid-efficiency system.

Line itemCost
3-ton condenser + coil, 16 SEER2$4,400
Air handler and line set$1,200
Labour, 2 days$2,400
Electrical circuit + disconnect$600
Permit and inspection$250
Total$8,850

That sits inside the $5,000 to $15,000 band, near the middle. If the same home needed new ductwork, add $3,000 to $8,000 — the total jumps to $12,000 to $17,000, which is why the duct question is the first question, not the last.

Mistakes to Avoid

  • Comparing a replacement quote to a first-install quote. They are different jobs. Make sure every quote prices the same scope — ducts included or not.
  • Sizing by square feet alone. A Manual J load calculation is the right way to size a system. An oversized unit costs more, wears out faster, and leaves the house humid.
  • Buying below the SEER2 minimum. It is illegal in your region, voids the warranty, and kills rebate eligibility.
  • Counting on the federal credit. It ended December 31, 2025 for equipment placed in service after that date.
  • Forgetting the electrical work. A first install usually needs a new circuit and disconnect — $600 or so that is easy to leave out of a headline price.

Frequently Asked Questions

How much does it cost to install central air conditioning?

About $5,000 to $15,000 with usable ductwork, checked Nov 11, 2026, and $9,000 to $18,000 with new ductwork. A straight replacement of an old unit costs $3,500 to $7,500.

What size central AC do I need?

Roughly one ton per 500 to 600 square feet: a 2-ton unit suits about 1,200 square feet, a 3-ton unit 1,800 to 2,000 square feet. A Manual J load calculation from the installer is the accurate answer — square footage alone is a rough guide.

Is a higher SEER2 rating worth it?

In hot climates where the AC runs most of the year, yes — the energy savings can pay back the $1,000 to $6,000 premium. In mild climates, the minimum-legal unit is usually the better buy.

How long does central AC installation take?

Four to eight hours for a replacement, two to three days for a first install with ductwork. Difficult retrofits in older homes can take three to five days.

Do I need a permit to install central air?

Yes, in almost every municipality. Permit fees typically run $100 to $400, and the work needs an inspection before the system is signed off.